HXXYYJ-40-60 Fully Automatic Compression Machine Tablet Press

HXXYYJ-40-60 Fully Automatic Compression Machine Tablet Press

HXXYYJ-40-60 compression machine and tablet press product description:

The HXXYYJ-40-60 prototype is a machine used for component analysis in metallurgy, non-ferrous metals, geology, cement, ceramics, electronic materials, and other fields. It compresses powder into test pieces and provides samples for X-ray spectrometers. Due to the strict requirements of the X-ray spectrometer for sample preparation, it is necessary to generate a large and stable pressure on the prototype to ensure the normal operation of the X-ray spectrometer. The HXXYYJ-40-60 compression machine is an ideal supporting equipment.

Working principle of HXXYYJ-40-60 compression machine and tablet press:

When started, relays ZJ2 and C1 work. Drive solenoid valve Y1 to open the oil circuit, and the electric motor drives the oil pump to generate oil pressure. Due to the opening of solenoid valve Y1, the piston in the oil cylinder moves upward. When the convex mold on the piston rod reaches its vertex, the electric contact pressure gauge controls the pressure, relay ZJ3 is disconnected, and the motor stops working. At this time, time relay SJ1 is working and in a pressure holding state. When the time relay reaches the set time, the SJ2 and ZJ4 solenoid valves Y2 open, and the piston of the oil cylinder descends. The stroke of piston descent is set by time relay SJ2.

Main technical parameters of HXXYYJ-40-60 compression machine and tablet press:

Maintenance of HXXYYJ-40-60 compression machine and tablet press:

Hydraulic system: This machine has very strict requirements for hydraulic oil, and the oil in the tank should be checked every six months according to the degree of use conditions to see if it has deteriorated and if there is any deterioration.

Mold: The mold matched with this machine is made of high-quality alloy steel, which has the characteristics of wear resistance, impact resistance, etc. It should be kept clean during use. After each sampling, it is necessary to clean the mold with an alcohol swab to ensure the cleanliness of the mold and the accuracy of sample preparation. In factories with a large number of samples, the molds should be disassembled and cleaned at least once per shift to prevent debris from damaging the molds. Method: This machine is equipped with a jog DA button switch on the control panel. Pressing this switch causes the piston to descend. When it descends 90 millimeters, stop removing the concave mold to remove dirt and install it. For public institutions and research institutes, the number of cleaning times can be appropriately reduced.