To ensure the quality of Ganoderma spore powder and improve production efficiency, it is necessary to standardize the operation and maintenance of Ganoderma spore powder cell wall breaking machines. Today, the editor will introduce to youOperating procedures for Ganoderma spore powder cell wall breaking machine.
1、 Confirm equipment status and parameters
Before operating the Ganoderma spore powder cell wall breaking machine, it is necessary to first check whether the equipment status and parameters meet the requirements. The specific operation steps are as follows:
1. Check if the device switch is in the off state and ensure that the power is turned off.
2. Check if the equipment is clean and remove any accumulated dust, dirt, and debris.
3. Check the grinding chips inside the equipment to confirm their normal condition, without cracks or damage.
4. Check if the water level is within the normal range and confirm if the water quality meets the specified standards.
5. Check if the oil level is within the normal range.
6. Add an appropriate amount of Ganoderma spore powder into the equipment and confirm if the amount added matches the equipment capacity.
7. Turn on the device power, turn on the heating switch, set the heating temperature, adjust the device to normal operation, and start breaking the wall when the temperature reaches the set value.
2、 Perform wall breaking
1. Add the Ganoderma spore powder cell wall breaking machine grinding chip into the equipment.
2. Cover the device with a lid, activate the device's running program, and ensure that the device is functioning properly.
3. Observe the working condition of the equipment to ensure that it operates normally, smoothly, without any abnormal vibration or noise. If any problems are found, immediately stop the equipment and conduct inspection and handling.
4. Based on the processed results, confirm that the device is functioning properly and restart it to ensure stable operation.
5. Wait for the equipment to finish working and confirm if the grinding effect is good.
3、 Cleaning equipment
1. Turn off the device switch, unplug the power plug, and wait for the device to stop running.
2. To clean the powder and dirt inside the equipment, specialized tools must be used for cleaning.
3. Clean the broken chips inside the equipment using specialized cleaning solution to remove bacteria and dirt.
4. Clean the surface of the equipment, being careful not to directly contact the equipment with water or other liquids.